ASL Calibration tab

Without calibration, perfusion values from ASL modelling are relative only and cannot be compared between subjects or sessions. By providing calibration data the perfusion can be output in physical units (ml/100g/min) allowing comparisons to be made.

Two calibration methods are provided: Voxelwise and Reference region. In both cases you must provide a calibration image and may override the default acquisition parameters for this image:

../_images/asl_calib_generic.png

Voxelwise calibration

In voxelwise calibration, the calibration image is converted to an M0 image and each voxel in the perfusion data is scaled by the voxelwise M0 value in the M0 image.

../_images/asl_calib_voxelwise.png

This requires two parameters, a notional T1 value for generic ‘tissue’ and a similar generic partition coefficient. The values given are from standard literature, however they can be modified if needed.

Reference region calibration

In reference region calibration a single M0 correction factor is determined for the whole image, by analysing a region of the data containing a single tissue type (typically CSF).

../_images/asl_calib_refregion.png

In order to do this, the reference region method requires an ROI which identifies a particular tissue type. By default this is calculated automatically for CSF using the following outline method:

  • Obtain the CSF mask from segmentation of the structural image
  • Register the structural image to a standard MNI brain image
  • Obtain (from standard atlases) the ventricle mask for the standard brain image
  • Erode the ventricle mask by 1 voxel and use it to mask the CSF mask from the structural image
  • Transform back into structural space and form the reference region mask by conservatively thresholding the ventricle mask at a threshold of 0.9

If a tissue type other than CSF is selected, only the first of these steps is performed.

You may prefer to supply a ready made reference ROI. This can be done using the Custom reference ROI option:

../_images/asl_calib_refregion_custom_roi.png

The T1, T2 and partition coefficient for this tissue type are required for calibration. The default values vary according to what tissue type you have selected - so the ones displayed above are appropriate for CSF. These can be modified as required.